LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2007 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Supplemental Restraint System) >> Service Information >> Side Curtain Air Bag Module >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2009 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • When servicing the SRS, do not work from directly in front of side curtain air bag module.
  • Always place the curtain air bag module with deployment side facing upward.
CAUTION:
  • Before servicing SRS, turn the ignition switch OFF, disconnect both battery terminals and wait at least three minutes.
  • Do not insert any foreign objects (screwdriver, etc.) into air bag module or harness connectors.
  • Do not attempt to disassemble side curtain air bag module.
  • Do not expose the side curtain air bag module to temperatures exceeding 90°C (194°F).
  • Replace the side curtain air bag module if it has been dropped or sustained an impact.
  • Do not allow oil, grease or water to come in contact with the side curtain air bag module.
  • Do not attempt to repair or replace damaged direct-connect SRS component connectors. If a direct-connect harness connector is damaged, the harness must be replaced.
Fig 1: Precaution For Handling Air Bag Module
G04927497Courtesy of NISSAN MOTOR CO., U.S.A.
  1. Disconnect both the negative and positive battery terminals, then wait at least three minutes.
  2. Remove the headlining. Refer to HEADLINING .
  3. Disconnect side curtain air bag module connector.
    Fig 2: Identifying Direct-Connect SRS Connectors
    G04887382Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Remove the front tether clips.
  5. Remove the side curtain air bag module bolts in order starting at the front or rear, then remove the side curtain air bag module.
scientia non olet · About LEMON Manuals