Inspection Procedure

Check self-diagnosis results.

Is the above displayed in the self-diagnosis display items? 

Yes: GO TO 2.

NO: Inspection End.

1. Disconnect the ABS actuator and electric unit (control unit) connector E125 and stop lamp switch connector E38.
2. Check the terminals for deformation, disconnection, looseness or damage.

OK or NG 

OK: GO TO 3.

NG: Repair or replace as necessary.

Turn the ignition switch ON and check the voltage between the ABS actuator and electric unit (control unit) connector E125 terminal 8 and ground.

8 - Ground 

Brake pedal depressed : Battery voltage (approx. 12V) 

Brake pedal not depressed : Approx. 0V 

OK or NG 

OK: Perform self-diagnosis again. If the same results appear, replace ABS actuator and electric unit (control unit). Refer to "REMOVAL AND INSTALLATION ".

NG: Repair the circuit.

Fig 1: Checking Voltage Between ABS Actuator And Electric Unit Connector E125 Terminal 8 And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.