LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2007 >> Murano SL, AWD >> Repair and Diagnosis >> Transmission >> Transfer Case >> Trouble Diagnosis >> AWD Control Unit Input/Output Signal Reference Values >> AWD Control Unit Inspection Table >> Specifications with CONSULT-II

Specifications with CONSULT-II

INPUT/OUTPUT SIGNAL REFERENCE VALUES

Monitored item [Unit] Content Condition Display value
FR RH SENSOR
(km/h) or (MPH)
Wheel speed
(Front wheel right)
Vehicle stopped 0.00 km/h (0.00 mph)
Vehicle running
CAUTION: Check air pressure of tire under standard condition.
Approximately equal to the indication on speedometer (Inside of ±10%)
FR LH SENSOR
(km/h) or (MPH)
Wheel speed
(Front wheel left)
Vehicle stopped 0.00 km/h (0.00 mph)
Vehicle running
CAUTION: Check air pressure of tire under standard condition.
Approximately equal to the indication on speedometer (Inside of ±10%)
RR RH SENSOR
(km/h) or (MPH)
Wheel speed
(Rear wheel right)
Vehicle stopped 0.00 km/h (0.00 mph)
Vehicle running
CAUTION: Check air pressure of tire under standard condition.
Approximately equal to the indication on speedometer (Inside of ±10%)
RR LH SENSOR
(km/h) or (MPH)
Wheel speed
(Rear wheel left)
Vehicle stopped 0.00 km/h (0.00 mph)
Vehicle running
CAUTION: Check air pressure of tire under standard condition.
Approximately equal to the indication on speedometer (Inside of ±10%)
BATTERY VOLT
(V)
Power supply voltage for AWD control unit Ignition switch: ON Battery voltage
THRTL POS SEN
(%)
Throttle opening condition When depressing accelerator pedal (Value rises gradually in response to throttle position.) 0 - 100%
ETS SOLENOID
(A)
Monitored value of current at AWD solenoid Engine speed
: At idle
AUTO Approx. 0.000A
LOCK Approx. 0.000A
Engine speed : 3,000 rpm or more constant AUTO Approx. 0.000 - 0.500A(1)
LOCK Approx. 1.800A
STOP LAMP SW
(ON/OFF)
Condition of brake pedal operation Brake pedal: Depressed ON
Brake pedal: Released OFF
ENG SPEED SIG
(RUN/STOP)
Condition of engine running Engine stopped
(Engine speed: Less than 400 rpm)
STOP
Engine running
(Engine speed: 400 rpm or more)
RUN
ETS ACTUATOR
(ON/OFF)
Operating condition of AWD actuator relay (integrated in AWD control unit) Engine stopped (Ignition switch: ON) OFF
Engine running ON
4WD WARN LAMP
(ON/OFF)
AWD warning lamp condition AWD warning lamp: ON ON
AWD warning lamp: OFF OFF
4WD MODE SW
(ON/OFF)
Input condition from AWD lock switch AWD lock switch OFF OFF
ON ON
4WD MODE MON
(AUTO/LOCK)
Control status of AWD
(Output condition of AWD
LOCK indicator lamp signal)
AWD LOCK indicator lamp (Engine running) OFF AUTO
ON LOCK
DIS-TIRE MONI (mm) Improper size tire installed condition Vehicle running with normal size tire installed 0-4 mm
Vehicle running with improper size tire installed (Front/rear tire size difference, wear condition) 4-8 mm, 8- mm
P BRAKE SW
(ON/OFF)
Condition of parking brake Parking brake operated ON
Parking brake not operated OFF
(1) The values are changed by throttle opening and engine speed.