DTC Confirmation Procedure

NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 8V at idle.

WITH CONSULT-II

Turn ignition switch ON.
Select "DATA MONITOR" mode with CONSULT-II.
Start engine and let it idle for 1 second.
If DTC is detected, go to , "DIAGNOSTIC PROCEDURE ".

Fig 1: CONSULT-II Display - DATA MONITOR
Courtesy of NISSAN NORTH AMERICA, INC.

WITH GST

Follow the procedure "WITH CONSULT-II" above.