LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2007 >> Murano SE >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P1217 To P2A03 >> DTC P2138 App Sensor >> Component Inspection >> Accelerator Pedal Position Sensor

Accelerator Pedal Position Sensor

  1. Reconnect all harness connectors disconnected.
  2. Turn ignition switch ON.
  3. Check voltage between ECM terminals 106 (APP sensor 1 signal), 98 (APP sensor 2 signal) and ground under the following conditions.
    TERMINALS VOLTAGE CHART

    Terminal Accelerator pedal Voltage
    106 (Accelerator pedal position sensor 1) Fully released 0.5 - 1.0V
    Fully depressed 4.2 - 4.8V
    98 (Accelerator pedal position sensor 2) Fully released 0.25 - 0.5V
    Fully depressed 2.0 - 2.5V
    Fig 1: Checking Voltage Between ECM Terminals 106 Or 98 And Ground
    G04900719Courtesy of NISSAN NORTH AMERICA, INC.
  4. If NG, replace accelerator pedal assembly and go to next step.
  5. Perform , "ACCELERATOR PEDAL RELEASED POSITION LEARNING ".
  6. Perform , "THROTTLE VALVE CLOSED POSITION LEARNING ".
  7. Perform , "IDLE AIR VOLUME LEARNING ".
scientia non olet · About LEMON Manuals