Diagnostic Procedure: Notes

Do you have CONSULT-II?

Yes or No

Yes: GO TO 2.

No: GO TO  3.

With CONSULT-II 

1. Start engine and let it idle.
2. Select "COOLING FAN" in "ACTIVE TEST" mode with CONSULT-II.
3. Make sure that cooling fans-1 and -2 operate at each speed (LOW/MID/HI).

OK or NG

OK: GO TO  4.

NG: Check cooling fan control circuit. (Go to , "COOLING FAN CONTROL CIRCUIT ".)

Fig 1: CONSULT-II Display - ACTIVE TEST

Courtesy of NISSAN NORTH AMERICA, INC.

Without CONSULT-II 

1. Perform IPDM E/R auto active test and check cooling fan motors operation, refer to , "AUTO ACTIVE TEST ".
2. Make sure that cooling fans-1 and -2 operate at each speed (Low/High).

OK or NG

OK: GO TO 4.

NG: Check cooling fan control circuit. (Go to , "COOLING FAN CONTROL CIRCUIT ".)

Refer to , "LEAK CHECK ".

OK or NG

OK: GO TO 5.

NG: Check the following for leak. Refer to , "LEAK CHECK ".

• Hose
• Radiator
• Water pump

Refer to , "CHECKING RADIATOR CAP ".

OK or NG

OK: GO TO 6.

NG: Replace radiator cap.

Check the following.

Thermostat. Refer to , "WATER INLET AND THERMOSTAT ASSEMBLY ".

Engine coolant temperature sensor. Refer to , "COMPONENT INSPECTION ".

OK or NG

OK: GO TO 7.

NG: Replace malfunctioning component.

If the cause cannot be isolated, go to , "MAIN 12 CAUSES OF OVERHEATING ".

: INSPECTION END