LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2007 >> Murano SE >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0448 To P1212 >> DTC P0452 EVAP Control System Pressure Sensor >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

  1. Start engine and warm it up to normal operating temperature.
  2. Turn ignition switch OFF and wait at least 10 seconds.
  3. Turn ignition switch ON.
  4. Select "DATA MONITOR" mode with CONSULT-II.
  5. Make sure that "FUEL T/TMP SE" is more than 0°C (32°F).
  6. Start engine and wait at least 20 seconds.

    If 1st trip DTC is detected, go to , "DIAGNOSTIC PROCEDURE ".

    Fig 1: CONSULT-II Display - DATA MONITOR
    G04900504Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals