TCM Inspection Table

Data are reference values and are measured between each terminal and ground.

Terminal	Wire color	Item	Condition			Data (Approx.)
1	R/Y	Pressure control solenoid valve A (Line pressure solenoid valve)	Courtesy of NISSAN MOTOR CO., U.S.A.	Release your foot from the accelerator pedal.		5.0 - 7.0 V
				Press the accelerator pedal all the way down.		1.0 - 3.0 V
2	W/B	Pressure control solenoid valve B (Secondary pressure solenoid valve)		Release your foot from the accelerator pedal.		5.0 - 7.0 V
				Press the accelerator pedal all the way down.		3.0 - 4.0 V
3	L/W	Torque converter clutch solenoid valve	Courtesy of NISSAN MOTOR CO., U.S.A.	When vehicle cruises in "D" position.	When CVT performs lock-up.	6.0 V
					When CVT does not perform lock-up.	1.0 V
4	L/Y	Lock-up select solenoid valve	Courtesy of NISSAN MOTOR CO., U.S.A.	Selector lever in "P" and "N" position		Battery voltage
				Wait at least for 5 seconds with the selector lever in "R" and "D" position		0 V
5	L	CAN-H	-			-
6	P	CAN-L	-			-
8	SB	Back-up lamp relay	Courtesy of NISSAN MOTOR CO., U.S.A.	Selector lever in "R" position.		0 V
				Selector lever in other positions.		Battery voltage
10	Y/L	Power supply	Courtesy of NISSAN MOTOR CO., U.S.A.	-		Battery voltage
			Courtesy of NISSAN MOTOR CO., U.S.A.	-		0 V
11	G/R	Step motor A	Within 2 seconds after ignition switch ON, the time measurement by using the pulse width measurement function (Hi level) of CONSULT-II.*1 CAUTION: Connect the diagnosis data link cable to the vehicle diagnosis connector. *1: A circuit tester cannot be used to test this item.			30.0 msec
12	O/B	Step motor B				10.0 msec
13	G/W	ROM assembly	-			-
14	L/R	ROM assembly	-			-
15	BR/R	ROM assembly	-			-
19	Y/L	Power supply	Courtesy of NISSAN MOTOR CO., U.S.A.	-		Battery voltage
			Courtesy of NISSAN MOTOR CO., U.S.A.	-		0 V
20	R	Step motor C	Within 2 seconds after ignition switch ON, the time measurement by using the pulse width measurement function (Hi level) of CONSULT-II.*1 CAUTION: Connect the diagnosis data link cable to the vehicle diagnosis connector. *1: A circuit tester cannot be used to test this item.			30.0 msec
21	R/G	Step motor D				10.0 msec
24	G/O	Starter relay	Courtesy of NISSAN MOTOR CO., U.S.A.	Selector lever in "N" and "P" position.		Battery voltage
				Selector lever in other positions.		0 V
25	B	Ground	Always			0 V
27	BR/W	PNP switch 1	Courtesy of NISSAN MOTOR CO., U.S.A.	Selector lever in "R", "N" and "D" positions.		0 V
				Selector lever in "P" position.		Battery voltage
28	W/L	Power supply (memory backup)	Always			Battery voltage
29	G	Output speed sensor(Secondary speed sensor)	Courtesy of NISSAN MOTOR CO., U.S.A.	When driving [M1 position, 20 km/h (12 MPH)].		400 Hz
32	GR	PNP switch 3 (monitor)	Courtesy of NISSAN MOTOR CO., U.S.A.	Selector lever in "D" position.		0 V
				Selector lever in "P", "R" and "N" positions.		8.0 V - Battery voltage
34	P/B	PNP switch 2		Selector lever in "N" and "D" positions.		0 V
				Selector lever in "P" and "R" positions.		10.0 V-Battery voltage
35	P/L	PNP switch 3		Selector lever in "D" position.		0 V
				Selector lever in "P", "R" and "N" positions.		8.0 V-Battery voltage
36	G	PNP switch 4		Selector lever in "R" and "D" positions.		0 V
				Selector lever in "P" and "N" positions.		10.0 V-Battery voltage
37	V/W	Transmission fluid pressure sensor A (Secondary pressure sensor)	Courtesy of NISSAN MOTOR CO., U.S.A.	"N" position idle		1.0 V
38	LG	Input speed sensor (Primary speed sensor)	Courtesy of NISSAN MOTOR CO., U.S.A.	When driving [M1 position, 20 km/h (12 MPH)].		660 Hz
41	V/O	Transmission fluid pressure sensor B (Primary pressure sensor)	Courtesy of NISSAN MOTOR CO., U.S.A.	"N" position idle		0.7 - 3.5 V
42	W/R	Sensor ground	Always			0 V
46	L/O	Sensor power	Courtesy of NISSAN MOTOR CO., U.S.A.	-		5.0 V
			Courtesy of NISSAN MOTOR CO., U.S.A.	-		0 V
47	V	CVT fluid temperature sensor	Courtesy of NISSAN MOTOR CO., U.S.A.	When CVT fluid temperature is 20°C (68°F)		2.0 V
				When CVT fluid temperature is 80°C (176°F)		1.0 V
48	B	Ground	Always			0 V