LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2006 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Brake System) >> Rear Disc Brake >> Disassembly and Assembly of Caliper Assembly >> Disassembly

Disassembly and Assembly of Caliper Assembly: Disassembly

WARNING: This page is about a different car, the 2007 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the sliding pin bolt, and then remove the pad, shim, shim cover, and pad retainer from the torque member and cylinder.
  2. Remove sliding pin boot from torque member.
  3. Remove the retaining ring from the cylinder body using a screwdriver or suitable tool, as shown.
    Fig 1: Identifying Retaining Ring
    G04876708
  4. Place a wooden block as shown, and blow air from connecting bolt mounting hole to remove pistons and piston boots.
    WARNING: Do not place your finger in front of piston.
    Fig 2: Blowing Air From Union Bolt
    G04876709
  5. Remove piston seals from cylinder body using a screwdriver or suitable tool, as shown.
    CAUTION: Be careful not to damage cylinder inner wall.
    Fig 3: Identifying Piston Seal
    G04902227
scientia non olet · About LEMON Manuals