LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2006 >> Sentra Base, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS U1000 To P0133 (QG18DE) >> DTC P0011 IVT Control >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

  1. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.
  2. Start engine and warm it up to the normal operating temperature.
  3. Maintain the following conditions for at least 6 consecutive seconds.

    Hold the accelerator pedal as steady as possible.

    DATA LIST

    ENG SPEED 1, 200 - 2, 000 rpm
    COOLAN TEMP/S 60 - 120 °C (140 - 248 °F)
    B/FUEL SCHDL More than 3.38 msec
    Selector lever AT models: P or N position
    MT models: Neutral position
    Fig 1: CONSULT II Display - Data Monitor
    G04074630Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Stop vehicle with engine running and let engine idle for 10 seconds.
  5. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".

    If 1st trip DTC is not detected, go to next step.

  6. Maintain the following conditions for at least 10 consecutive seconds.
    DATA LIST

    ENG SPEED 1, 700 - 3, 175 rpm (A constant rotation is maintained.)
    COOLAN TEMP/S 70 - 105°C (176 - 194 °F)
    Selector lever 1st or 2nd position
    Driving location uphill Driving vehicle uphill (Increased engine load will help maintain the driving conditions required for this test.)
  7. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
scientia non olet · About LEMON Manuals