Testing Condition:

Steps 4 and 5 may be conducted with the drive wheels lifted in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle. 

1. Start engine (TCS switch or VDC switch OFF).
2. Select "DATA MONITOR" mode with CONSULT-II.
3. Press MAIN switch and make sure that CRUISE indictor lights up.
4. Drive the vehicle for at least 5 consecutive seconds under the following condition.
   SPECIFIED CONDITIONS
   
   

   VHCL SPEED SE	More than 30 km/h (19 MPH)
   Shift lever	Suitable position

   Fig 1: CONSULT-II Display - Data Monitor

   Courtesy of NISSAN MOTOR CO., U.S.A.

   If 1st trip DTC is detected, go to , "DIAGNOSTIC PROCEDURE ".

   If 1st trip DTC is not detected, go to the following step.

5. Drive the vehicle for at least 5 consecutive seconds under the following condition.
   SPECIFIED CONDITIONS
   
   

   VHCL SPEED SE	More than 30 km/h (19 MPH)
   Shift lever	Suitable position
   Driving location	Depress the brake pedal for more than 5 seconds so as not to come off from the above-mentioned vehicle speed.

6. If 1st trip DTC is detected, go to , "DIAGNOSTIC PROCEDURE ".