Reference Value From Consult-II
CAUTION:
The display shows control unit calculation data, so a normal value might be displayed even in the event the output circuit (harness) is open or short - circuit.
DATA MONITOR REFERENCE VALUE CHART
| Monitor item | Display content | Data monitor | Check item | |
|---|---|---|---|---|
| Condition | Reference value in normal operation | |||
| FR RH SENSOR FR LH SENSOR RR RH SENSOR RR LH SENSOR | Wheel speed | Vehicle stopped | 0 [km/h] | "WHEEL SENSOR " |
| Vehicle running (Note 1) | Almost in accordance with speedometer display (within +/- 10 %) | |||
| BATTERY VOLT | Battery voltage supplied to ABS actuator and electric unit (control unit) | Ignition switch ON | 10-16V | "ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) POWER SUPPLY AND GROUND CIRCUIT " |
| STOP LAMP SW | Brake pedal operation | Brake pedal depressed | ON | - |
| Brake pedal not depressed | OFF | |||
| ABS WARN LAMP | ABS warning lamp ON condition (Note 2) | ABS warning lamp ON | ON | - |
| ABS warning lamp OFF | OFF | |||
| MOTOR RELAY | Operation status of motor and motor relay | Ignition switch ON or engine running (ABS not operated) | OFF | "ACTUATOR MOTOR, MOTOR RELAY, AND CIRCUIT " |
| Ignition switch ON or engine running (ABS operated) | ON | |||
| ACTUATOR RLY | Actuator relay operation status | Vehicle stopped (Ignition switch ON) | OFF | "ACTUATOR MOTOR, MOTOR RELAY, AND CIRCUIT " |
| Vehicle stopped (Engine running) | ON | |||
| FR LH IN SOL FR LH OUT SOL FR RH IN SOL FR RH OUT SOL RR RH IN SOL RR RH OUT SOL RR LH IN SOL RR LH OUT SOL | Solenoid valve operation | Actuator (solenoid) is active ("ACTIVE TEST" with CONSULT-II) or actuator relay is inactive (in fail-safe mode). | ON | "SOLENOID VALVE CIRCUIT " |
| When actuator (solenoid) is not active and actuator relay is active (ignition switch ON). | OFF | |||
| ABS FAIL SIG EBD FAIL SIG | Fail signal status | ABS fail EBD fail | ON | ABS system EBD system |
| EBD normal ABS normal | OFF | |||
| DECEL G-SEN | Longitudinal acceleration detected by Decel G-Sensor | Vehicle stopped | Approx. 0 G | "G SENSOR SYSTEM " |
| Vehicle running | -1.7 - + 1.7 G | |||
| EBD WARN LAMP | Brake warning lamp on condition (Note 3) | Brake warning lamp ON | ON | - |
| Brake warning lamp OFF | OFF | |||
| EBD SIGNAL | EBD operation | EBD active | ON | |
| EBD not active | OFF | |||
| ABS SIGNAL | ABS operation | ABS active | ON | |
| ABS not active | OFF | |||
| Note 1: Confirm tire pressure is normal. Note 2: ON/OFF timing of ABS warning lamp ON: For approximately 2 seconds after ignition switch is turned ON, or when a malfunction is detected. OFF: Approximately 2 seconds after ignition switch is turned ON (when system is in normal operation). Note 3: Serves as EBD warning lamp. |
||||