Inspection Procedure

CHECK SELF-DIAGNOSTIC RESULTS

With CONSULT-II

Turn ignition switch "ON". (Do not start engine.)
Select "SELF-DIAG RESULTS" mode for "ABS" with CONSULT-II.
Touch "ERASE".
Turn ignition switch "OFF" and wait at least 10 seconds.
Check the self-diagnostic results.

RESULT CHART

Self-diagnostic results
ENGINE SIGNAL 1
ENGINE SIGNAL 2
ENGINE SIGNAL 3
ENGINE SIGNAL 4
ENGINE SIGNAL 6

Is above displayed in the self-diagnosis display?

YES: GO TO 2.

NO: INSPECTION END

CHECK ENGINE SYSTEM
1. Perform an ECM self-diagnosis and repair or replace any malfunction items. Perform the ECM self-diagnosis again.
2. Perform ABS actuator and electric unit (control unit) self-diagnosis again.
OK or NG

OK: INSPECTION END

NG :
- Repair or replace malfunctioning components.
- Perform the self-diagnosis, and make sure that the result shows "NO DTC IS DETECTED".