LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2006 >> Armada LE, 4WD >> Repair and Diagnosis >> Engine Performance >> System >> Transfer Case >> Transfer Assembly >> Removal and Installation >> Removal

Removal and Installation: Removal

  1. Remove the drain plug and gasket. Drain the fluid. Refer to "DRAINING ".
  2. Remove the A/T undercover using power tool.
  3. Remove the center exhaust tube and main muffler. Refer to "REMOVAL ".
  4. Remove the front and rear propeller shafts. Refer to "REMOVAL " (front), "REMOVAL " (rear).
    CAUTION: Do not damage spline, sleeve yoke and rear oil seal when removing rear propeller shaft.
    NOTE: Insert a plug into the rear oil seal after removing the rear propeller shaft.
  5. Remove the A/T nuts from the A/T crossmember.
  6. Position two suitable jacks under the A/T and transfer assembly.
  7. Remove the crossmember. Refer to "COMPONENTS ".
    WARNING: Support A/T and transfer assembly using two suitable jacks while removing crossmember.
  8. Disconnect the electrical connectors from the following:
    • ATP switch
    • Neutral 4LO switch
    • Wait detection switch
    • Transfer motor
    • Transfer control device
    • Transfer terminal cord assembly
  9. Disconnect each air breather hose from the following. Refer to "REMOVAL AND INSTALLATION ".
    • Actuator
    • Breather tube (transfer)
    • Transfer motor (case connector)
  10. Remove the transfer control device from the extension housing.
  11. Remove the transfer to A/T and A/T to transfer bolts.
    WARNING: Support transfer assembly with suitable jack while removing it.
  12. Remove the transfer assembly.
scientia non olet · About LEMON Manuals