LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2006 >> Altima SE-R, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 236 (Power Steering System) >> Power Steering Oil Pump >> Disassembly and Assembly >> Disassembly

Disassembly and Assembly: Disassembly

WARNING: This page is about a different car, the 2005 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Mount the oil pump in a vise as needed.
CAUTION: When retaining drive shaft in a vise, always use copper or aluminum plates between vise and shaft.
  1. Unscrew three bracket bolts and remove bracket from rear cover.
  2. Unscrew four rear cover bolts and remove rear cover from body assembly.
  3. Remove gasket from body assembly.
  4. Remove lock pin, cartridge and side plate from body assembly.
  5. Remove pulley from drive shaft assembly.
  6. Remove snap ring from drive shaft assembly, then press out drive shaft assembly.
    CAUTION: When removing snap ring, be careful not to damage drive shaft assembly.
    Fig 1: Removing Snap Ring From Drive Shaft Assembly
    G03599749Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Using a screwdriver, remove oil seal from body assembly.
    Fig 2: Removing Oil Seal From Body Assembly
    G03599750Courtesy of NISSAN MOTOR CO., U.S.A.
  8. Remove O-ring from body assembly.
  9. Remove connector bolt, then flow control valve and spring from body assembly.
    CAUTION: Be careful not to drop and deform the flow control valve.
    Fig 3: Removing Flow Control Valve & Spring From Body Assembly
    G03599751Courtesy of NISSAN MOTOR CO., U.S.A.
  10. Remove suction pipe from body assembly.
  11. Remove O-ring for suction pipe.
scientia non olet · About LEMON Manuals