LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2006 >> 350Z 2D Convertible, Standard >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Control System - Component And System Testing >> ASCD Brake Switch >> Component Inspection >> Stop Lamp Switch

Stop Lamp Switch

  1. Turn ignition switch OFF.
  2. Disconnect stop lamp switch harness connector.
  3. Check continuity between stop lamp switch terminals 1 and 2 under the following conditions.
    CONTINUITY REFERENCE

    Condition Continuity
    Brake pedal: Fully released Should not exist
    Brake pedal: Slightly depressed Should exist
    Fig 1: Checking Continuity Between Stop Lamp Switch Terminals 1 And 2
    G04081094Courtesy of NISSAN NORTH AMERICA, INC.

    If NG, adjust stop lamp switch installation, Refer to "BRAKE PEDAL ", and perform step  3 again.

scientia non olet · About LEMON Manuals