Inspection Procedure

WARNING: This page is about a different car, the 2007 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the double meter for damage, bend and loose connection (unit side and connector side).
OK or NG

OK: GO TO 2.

NG: Repair the terminal and connector.

CHECK HARNESS FOR OPEN CIRCUIT

Disconnect the connector of double meter.

Check the resistance between the double meter harness connector terminals.

CONNECTOR TERMINAL RESISTANCE SPECIFICATION

Double meter harness connector			Resistance (Ω)
Connector No.	Terminal No.		Resistance (Ω)
M89	1	2	Approx. 54 - 66

OK or NG

OK: GO TO 3.

NG: Repair the double meter branch line.

CHECK POWER SUPPLY AND GROUND CIRCUIT
Check the power supply and the ground circuit of the double meter. Refer to "POWER SUPPLY AND GROUND CIRCUIT CHECK ".

OK or NG

OK:
- Present error: Replace the double meter. Refer to "REMOVAL AND INSTALLATION ".
- Past error: Error was detected in the double meter branch line.
NG: Repair the power supply and the ground circuit.