Diagnostic Trouble Codes Confirmation Procedure

NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 10V at idle.

WITH CONSULT-II

Turn ignition switch ON.
Select "DATA MONITOR" mode with CONSULT-II.

Fig 1: CONSULT-II Display - DATA MONITOR Mode
Courtesy of NISSAN MOTOR CO., U.S.A.
Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON.
Repeat steps 3 and 4, 32 times.
If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE "

WITH GST

Follow the procedure "WITH CONSULT-II" above.