Stop Lamp Switch

WARNING: This page is about a different car, the 2005 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch OFF.
Disconnect stop lamp switch harness connector.

Check harness continuity between stop lamp switch terminals 1 and 2 under the following conditions.

STOP LAMP SWITCH CONTINUITY

Condition	Continuity
When brake pedal: Fully released.	Should not exist.
When brake pedal: Depressed.	Should exist.

If NG, adjust stop lamp switch installation, refer to BRAKE PEDAL and perform step 3 again.

Fig 1: Checking Continuity Between Stop Lamp Switch Terminals

Courtesy of NISSAN MOTOR CO., U.S.A.