LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2005 >> Quest Base >> Repair and Diagnosis >> Engine Performance >> Engine Control System >> DTC P0453: EVAP Control System Pressure Sensor >> Diagnostic Trouble Codes Confirmation Procedure >> With GST

With GST

  1. Start engine and warm it up to normal operating temperature.
  2. Check that voltage between ECM terminal 107 (Fuel tank temperature sensor signal) and ground is less than 4.2V.
    Fig 1: Checking Voltage Between ECM Terminal 107 & Ground
    G02474158Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Turn ignition switch OFF and wait at least 10 seconds.
  4. Wait at least 10 seconds.
  5. Select "Service $07" with GST.

    If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE "

scientia non olet · About LEMON Manuals