LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Xterra SE, RWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - VG33E >> DTC P1148, P1168: Closed Loop Control >> Overall Function Check >> With GST

With GST

  1. Start engine and warm it up to normal operating temperature.
  2. Set voltmeter probes between ECM terminal 50 [HO2S1 (B1) signal] or 51 [HO2S1 (B2) signal] and engine ground.
  3. Check the following with engine speed held at 2, 00 RPM constant under no load.
    • The voltage should go above 0.70V at least once.
    • The voltage should go below 0.21V at least once.
  4. If NG, go to Diagnostic Procedure  .
    Fig 1: Setting Voltmeter Probes Between ECM Terminal 50 & 51
    G00870648Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals