LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Xterra SE, RWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - VG33E >> DTC P0453: EVAP Control System Pressure Sensor >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

  1. Start engine and warm it up to normal operating temperature.
  2. Turn ignition switch OFF and wait at least 10 seconds.
  3. Turn ignition switch ON.
  4. Select "DATA MONITOR" mode with CONSULT-II.
    Fig 1: Identifying Display
    G00870212Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Make sure that "FUEL T/TMP SE" is more than 0°C (32°F).
  6. Start engine and wait at least 20 seconds.
  7. If 1st trip DTC is detected, go to Diagnostic Procedure  .
scientia non olet · About LEMON Manuals