Diagnostic Trouble Code (DTC) Confirmation Procedure

CAUTION:

Always drive vehicle at a safe speed.
If conducting this "DTC CONFIRMATION PROCEDURE" again, always turn ignition switch OFF and wait at least 5 seconds before continuing.

After the repair, perform the following procedure to confirm the malfunction is eliminated.

With CONSULT-II

Start engine.

Fig 1: Consult II Display (1 Of 2)
Courtesy of NISSAN MOTOR CO., U.S.A.
Select "DATA MONITOR" mode for "A/T" with CONSULT-II.
Drive vehicle under the following conditions:
Selector lever in D, vehicle speed higher than 40 km/h (25 MPH), engine speed higher than 1, 500 rpm, throttle opening greater than 1.0/8 of the full throttle position and driving for more than 5 seconds.

Without CONSULT-II

Start engine.
Drive vehicle under the following conditions:
Selector lever in "D" and vehicle speed higher than 40 km/h (25 MPH), engine speed higher than 1, 500 rpm, throttle opening greater than 1/8 of the full throttle position and driving for more than 5 seconds.

Fig 2: Consult II Display (2 Of 2)
Courtesy of NISSAN MOTOR CO., U.S.A.
Perform self-diagnosis.
Refer to "TCM SELF-DIAGNOSTIC PROCEDURE (NO TOOLS) ".

Fig 3: Identifying Pattern Of Light

G00901746

Courtesy of NISSAN MOTOR CO., U.S.A.