LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Manual Transaxle - RS5F70A) >> Final Drive >> Disassembly

Final Drive: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. Remove mounting bolts. Then, separate the final gear from differential case.
    Fig 1: Removing Final Gear
    G00777383Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Make a notch and remove speedometer drive gear using a scraper or other suitable tool.
    • Bearing replacer cannot be positioned unless speedometer drive gear is removed. 
  3. Remove differential side bearing of final gear side using Tool.
  4. Turn differential case upside down, and remove differential side bearing of speedometer drive gear side using Tool.
    • Be careful not to mix up the differential side bearings. 
      Fig 2: Removing Differential Side Bearing Of Speedometer Drive Gear
      G00777384Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Remove speedometer stopper.
  6. Remove lock pins from pinion mate shaft using Tool.
    Fig 3: Removing Lock Pins From Pinion Mate Shaft
    G00777385Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Remove pinion mate shaft.
  8. Rotate pinion mate gear, and remove pinion mate gear, pinion mate thrust washer, side gear, and side gear thrust washer from differential case.
    Fig 4: Removing Pinion Mate Gear
    G00777386Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals