Removal And Installation

WARNING: This page is about a different car, the 2003 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.

Refer to Figure for tightening torque. Install in the reverse order of removal.
NOTE: Refer to component parts location and do not reuse non-reusable parts.
Ensure that hose touches spool of tube when tube is to be inserted to hose.

Fig 1: Identifying Tube, Spool And Hose
Courtesy of NISSAN MOTOR CO., U.S.A.

CAUTION: Do not apply power steering fluid to the junction surface between tube and hose.
To install eye joint, join projection of eye joint into notch of power steering pump, and attach eye joint to power steering pump properly. Then, fully tighten eye bolt by hands, and tighten it to a specified torque.

Fig 2: Tightening Eye Bolt To Specified Torque
Courtesy of NISSAN MOTOR CO., U.S.A.
Connect harness connector into pressure sensor securely.