Sunroof Switch System Check

1. Turn ignition switch OFF.
2. Check voltage between sunroof switch connector R53 terminal 2 and ground.

   (Y/G) - Ground: Battery voltage 

OK or NG 

1. OK: GO TO 2.
2. NG:
   • Check 10A fuse [No. 19 located in fuse block (J/B)].
   • Check harness for open or short between sunroof switch and fuse.
     Fig 1: Checking Voltage Between Sunroof Switch Connector R53 Terminal 2 And Ground

     Courtesy of NISSAN MOTOR CO., U.S.A.

1. Disconnect sunroof switch connector.
2. Operate sunroof switch, and check continuity between terminals 1 and 3, and terminal 2 on the sunroof switch connector R53 in each of the switch positions.

   TILT UP switch operation 

   2-3: Continuity should exist. 

   CLOSE switch operation 

   2-3: Continuity should exist. 

   TILT DOWN switch operation 

   1-2: Continuity should exist. 

   OPEN switch operation 

   1-2: Continuity should exist. 

OK or NG 

1. OK: GO TO 3.
2. NG: Replace sunroof switch.
   Fig 2: Checking Continuity Between Terminals 1 And 3, And Terminal 2 On Sunroof Switch Connector R53

   Courtesy of NISSAN MOTOR CO., U.S.A.

1. Disconnect sunroof motor assembly connector.
2. Check continuity between sunroof motor assembly connector R6 terminals 1, 2 and sunroof switch connector R53 terminals 1, 3.

   (L/R) - 3 (L/R): Continuity should exist. 

   (L/B) - 1 (L/B): Continuity should exist. 

3. Check continuity between sunroof motor assembly connector R6 terminals 1, 2 and ground.

   1 (L/R) - Ground: Continuity should not exist. 

   2 (L/B) - Ground: Continuity should not exist. 

OK or NG 

1. OK: Sunroof switch system is OK.
2. NG: Repair or replace harness between sunroof motor assembly and sunroof switch.
   Fig 3: Checking Continuity Between Sunroof Motor Assembly Connector R6 Terminals 1, 2 And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.