LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 427 (Engine Mechanical) >> Cylinder Block >> Inspection After DisassemblY >> Oil Clearance Of Connecting Rod Bearing >> Method by Calculation

Method by Calculation

WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the connecting rod bearing to the connecting rod and cap.
  2. Install the connecting rod cap to the connecting rod. Tighten to specification. Refer to "ASSEMBLY ".
  3. Measure the inner diameter "C" of each connecting rod (big end) as shown.
    Fig 1: Measure The Inner Diameter "C" Of Each Connecting Rod (Big End) As Shown
    G00877092Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Measure the outer diameter "Dp" of each crankshaft pin journal.
  5. Calculate the connecting rod bearing clearance.

    Connecting rod bearing clearance = C - Dp

    1. Standard: 0.034 - 0.059 mm (0.0013 - 0.0023 in) 
    2. Limit: 0.070 mm (0.0028 in) 
  6. If the clearance cannot be adjusted within the standard of any bearing, grind the crankshaft journal and use undersized bearings. Refer to "HOW TO SELECT CONNECTING ROD BEARINGS ".
Fig 2: Measure The Outer Diameter "Dp" Of Each Crankshaft Pin Journal
G00877093Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals