Telescopic Sensor Circuit Inspection

WARNING: This page is about a different car, the 2004 Infiniti M45. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FUNCTION
With CONSULT-II

Operate the telescopic switch with "TELESCO SEN" on the DATA MONITOR to check that the voltage changes.

Fig 1: Checking Function
Courtesy of NISSAN MOTOR CO., U.S.A.

Without CONSULT-II
1. Turn ignition switch OFF.
2. Check voltage between BCM connector and body ground.
  
  Fig 2: Checking Voltage Between BCM Connector & Body Ground (1 Of 2)
  Courtesy of NISSAN MOTOR CO., U.S.A.
  
  Fig 3: Checking Voltage Between BCM Connector & Body Ground (2 Of 2)
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
1. OK: System is OK.
2. NG: GO TO 2.
CHECK STEERING WHEEL TILT MECHANISM
Check the operation malfunction caused by steering wheel tilt mechanism deformation or parts are loose.

OK or NG
1. OK: GO TO 3.
2. NG: Repair the malfunctioning parts.
CHECK HARNESS CONTINUITY
1. Disconnect BCM and telescopic sensor connector.
2. Check continuity harness between BCM connector M4 terminals 53 (L/B), 54 (R), 62 (P/B) and telescopic sensor connector M59 terminals 1 (R), 2 (P/B), 3 (L/B).
  53 (L/B) - 3 (L/B): Continuity should exist.
  
  54(R) - 1 (R): Continuity should exist.
  
  62 (P/B) - 2 (P/B): Continuity should exist.
3. Check continuity harness between BCM connector M59 terminals 53 (L/B), 54 (R), 62 (P/B) and body ground.
  53 (L/B) - Ground: Continuity should not exist.
  
  54 (R) - Ground: Continuity should not exist.
  
  62 (P/B) - Ground: Continuity should not exist.
OK or NG
1. OK: Replace telescopic sensor.
2. NG: Repair or replace harness between BCM and telescopic sensor
Fig 4: Checking Harness Continuity
Courtesy of NISSAN MOTOR CO., U.S.A.