LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 412 (Engine Control System) >> DTC P0122, P0123: TP Sensor >> Component Inspection >> Throttle Position Sensor

Throttle Position Sensor

WARNING: This page is about a different car, the 2004 Infiniti M45. However, it is still accessible from the selected car via links, so may be relevant.
  1. Reconnect all harness connectors disconnected.
  2. Perform ACCELERATOR PEDAL RELEASED POSITION LEARNING .
  3. Perform THROTTLE VALVE CLOSED POSITION LEARNING .
  4. Turn ignition switch ON.
  5. Set selector lever to D position.
  6. Check voltage between ECM terminals 108 (TP sensor 1signal), 98 (TP sensor 2signal) and ground under the following conditions.
    Fig 1: Identifying Throttle Position Sensor Information
    G00795771Courtesy of NISSAN MOTOR CO., U.S.A.
  7. If NG, replace electric throttle control actuator and go to the next step.
  8. Perform ACCELERATOR PEDAL RELEASED POSITION LEARNING .
  9. Perform THROTTLE VALVE CLOSED POSITION LEARNING .
  10. Perform IDLE AIR VOLUME LEARNING .
scientia non olet · About LEMON Manuals