LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 398 (Air Bag Restraint Systems) >> Disposal Procedures >> Off-Vehicle Deployment >> Driver-side AIR Bag Module

Driver-side AIR Bag Module

WARNING: This page is about a different car, the 2004 Infiniti M45. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS  . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM  . Remove driver-side air bag module from vehicle and place on clean, dry, work bench with trim cover facing upward. See DRIVER-SIDE AIR BAG MODULE  under REMOVAL & INSTALLATION.
  2. Using wire at least 0.04" (1 mm) in diameter, secure air bag module to Air Bag Module Bracket (J41246) in 2 places. See Fig 1 . Firmly secure air bag module bracket in vise.
  3. Position a fully charged 12-volt battery at least 16 feet (4.9 m) from deployment area. Connect Air Bag Deployment Tool (J38381) to driver-side air bag module connector using Deployment Tool Adapter (J38381-70). Connect Red deployment tool clip to positive battery terminal and Black deployment tool clip to negative battery terminal.
  4. Ensure deployment tool power lamp glows Green. If deployment tool power lamp glows Red, reverse battery connections and recheck lamp. Ensure no one is within 16 feet (4.9 m) of air bag module. Press deployment tool button to deploy air bag module.
Fig 1: Deploying Driver-side Air Bag Module
G99J25857Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals