Current Codes Using Consult Tester
WARNING: This page is about a different car, the 2004 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition off. Connect CONSULT tester and CONSULT CONVERTER to Data Link Connector (DLC), located under left side of instrument panel. See Fig 1 . Turn ignition on. Touch START (NISSAN BASED VHCL) on CONSULT tester. Touch AIR BAG. Touch SELF-DIAG (CURRENT).
- If any problems are present, message will be displayed in SELF-DIAG (CURRENT) mode. Go to PRESENT FAULT MESSAGES . Touch PRINT. Touch BACK until SELECT SYSTEM appears. Turn ignition off. Turn off CONSULT tester. Disconnect CONSULT tester and CONSULT CONVERTER from DLC. Disconnect both battery cables. After repair is completed, codes must be cleared. See CLEARING CODES .