LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 355 (Power Steering System) >> Power Steering Oil Pump >> Disassembly And Assembly >> Disassembly

Disassembly And Assembly: Disassembly

WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Parts which can be disassembled are strictly limited. Never disassemble parts other than those specified.
  • Disassemble in as clean a place as possible.
  • Clean your hands before disassembly.
  • Do not use rags; use nylon cloths or paper towels.
  • Follow the procedures and cautions in the Service Manual.
  • When disassembling and reassembling, do not let foreign matter enter or contact the parts.
  1. Remove snap ring, then draw drive shaft out.
    • Be careful not to drop drive shaft.
    Fig 1: Removing Drive Shaft
    G00331640Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Remove oil seal.
    CAUTION: Be careful not to damage front housing.
    Fig 2: Removing Oil Seal
    G00331641Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Remove connector and flow control valve with spring.
    CAUTION: Be careful not to drop flow control valve.
    Fig 3: Removing Connector And Flow Control Valve With Spring
    G00331642Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Inspect all of the power steering oil pump components, and repair or replace as necessary. Refer to "INSPECTION AFTER DISASSEMBLY ".
scientia non olet · About LEMON Manuals