Disassembly And Assembly: Assembly

WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Install the inner tie-rods.
Install the outer tie-rods to the specified length and tighten the outer socket lock nut. Refer to "STEERING GEAR AND LINKAGE ".

Fig 1: Installing The Outer Tie-Rods To The Specified Length
Courtesy of NISSAN MOTOR CO., U.S.A.

Use Genuine High Temperature, High Strength Thread Locking Sealant (Red) or equivalent. Refer to "RECOMMENDED CHEMICAL PRODUCTS AND SEALANTS ".
1. Outer socket lock nut :37 - 46 N.m (3.8 - 4.7 kg-m, 27 - 34 ft-lb)
Measure rack stroke. Refer to "STEERING GEAR AND LINKAGE ".

Fig 2: Measuring Rack Stroke
Courtesy of NISSAN MOTOR CO., U.S.A.
Before installing boot, coat the contact surfaces between boot and tie-rod with grease.

Fig 3: Installing Boot
Courtesy of NISSAN MOTOR CO., U.S.A.
Install the boot clamps and crimp securely.

Fig 4: Installing Boot Clamp
Courtesy of NISSAN MOTOR CO., U.S.A.