LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 236 (Specifications & Procedures) >> Wheel Alignment Inspection >> Using a CCK Gauge

Using a CCK Gauge

WARNING: This page is about a different car, the 2003 Infiniti M45. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove wheel nuts (3), and install a guide bolt (special service tool) to hub bolt.
  2. Screw adapter (special service tool) into plate body (special service tool) until it contacts body tightly.
  3. Screw center plate (special service tool) into plate body (special service tool).
  4. Insert plate (special service tool) on guide bolt (special service tool). Put spring in, and then evenly screw in guide bolt nut (special service tool). When fastening guide bolt nut, do not completely compress spring.
    Fig 1: Insert Plate (Special Service Tool) On Guide Bolt
    G00749035Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Place the dent of alignment gauge onto the projection of center plate (special service tool) and tightly contact them to measure.
    • Standard value 
    • Camber, caster, kingpin inclination angles: Refer to  SPECIFICATIONS  .
    CAUTION:
    • If camber, caster, or kingpin inclination angle is outside the standard, check front suspension parts for wear and damage, and replace suspect parts if necessary.
    • King pin inclination angle is reference value, no inspection is required.
    Fig 2: Alignment Gauge
    G00749036Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals