LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 2287 (Engine Control System - DTCS P1211 Through P2A03) >> DTC P1572 ASCD Brake Switch >> DTC Confirmation Procedure >> With Consult-III

With Consult-III

WARNING: This page is about a different car, the 2008 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

TESTING CONDITION: 

Steps   4  and   7  may be conducted with the drive wheels lifted in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle. 

  1. Start engine (TCS switch or VDC switch OFF).
  2. Select "DATA MONITOR" mode with CONSULT-III.
  3. Press MAIN switch and make sure that CRUISE indictor lights up.
  4. Drive the vehicle for at least 5 consecutive seconds under the following condition.
    VEHICLE SPEED CONDITION

    VHCL SPEED SE More than 30 km/h (19 MPH)
    Shift lever Suitable position
  5. Check 1st trip DTC.
  6. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".

    If 1st trip DTC is not detected, go to the following step.

  7. Drive the vehicle for at least 5 consecutive seconds under the following condition.
    VEHICLE SPEED CONDITION

    VHCL SPEED SE More than 30 km/h (19 MPH)
    Shift lever Suitable position
    Driving location Depress the brake pedal for more than 5 seconds so as not to come off from the above-mentioned vehicle speed.
  8. Check 1st trip DTC.
  9. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
scientia non olet · About LEMON Manuals