LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 2284 (Engine Control System - DTCS U1000 Through P0153) >> DTC P0128 Thermostat Function >> DTC Confirmation Procedure >> With Consult-III

With Consult-III

WARNING: This page is about a different car, the 2008 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn A/C switch OFF.
  2. Turn blower fan switch OFF.
  3. Turn ignition switch ON.
  4. Select "COOLAN TEMP/S" in "DATA MONITOR" mode with CONSULT-III.
  5. Check the indication of "COOLAN TEMP/S".

    If it is below 71°C (160°F), go to following step.

    If it is above 71°C (160°F), cool down the engine to less than 71°C (160°F), then go to next step.

  6. Start engine.
  7. Wait at idle for a least 30 minutes.

    If "COOLAN TEMP/S" increases to more than 71°C (160°F) within 30 minutes, turn ignition switch OFF because the test result will be OK. 

  8. Check 1st trip DTC.
  9. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
scientia non olet · About LEMON Manuals