Precaution for Harness Repair

WARNING: This page is about a different car, the 2012 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Solder the repaired area and wrap tape around the soldered area.
NOTE: A fray of twisted lines must be within 110 mm (4.33 in).

Fig 1: Identifying Repaired Area Soldered And Wrapped With Tape
Courtesy of NISSAN NORTH AMERICA, INC.
Bypass connection is never allowed at the repaired area.
NOTE: Bypass connection may cause CAN communication error. The spliced wire becomes separated and the characteristics of twisted line are lost.

Fig 2: Precaution For Bypass Wire Connections
Courtesy of NISSAN NORTH AMERICA, INC.
Replace the applicable harness as an assembly if error is detected on the shield lines of CAN communication line.