Removal and Installation: Installation

WARNING: This page is about a different car, the 2008 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

Tighten the transverse link mounting bolts and nuts to specified torque, refer to "COMPONENTS ".
During installation, the final tightening must be done with the vehicle at curb weight and the tires on the ground.

CAUTION: Discard the old pinch nut and use a new pinch nut for installation of the lower ball joint pinch bolt.
After installation, check the wheel alignment. Refer to "FRONT WHEEL ALIGNMENT ".
Install the wheel and tire. Refer to "ROTATION ".