LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 2098 (Front Suspension System) >> Stabilizer Bar >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2008 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel and tire using power tool. Refer to "ROTATION ".
  2. Remove the steering gear bolts on the lower side. Refer to "REMOVAL AND INSTALLATION ".
    • Support steering gear.
  3. Disconnect the connecting rod end at the stabilizer bar using power tool.
    • Prevent the connecting rod from turning by inserting a hex wrench into the end of the ball stud, then remove nut.
  4. Remove the two stabilizer bar clamps from the front suspension member.
  5. Remove the stabilizer bar by withdrawing from side.
    • Remove the two stabilizer bushings as necessary.
      Fig 1: Identifying Strut And Connecting Rod
      G04887044Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals