Door Switch Check
WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK DOOR SWITCH INPUT SIGNAL
With CONSULT-III
Check door switches ("DOOR SW-DR" and "DOOR SW-AS") in "DATA MONITOR" mode with CONSULT-III.
DOOR SW-DR" AND "DOOR SW-ASMonitor item Door condition DOOR SW-DR OPEN :ON CLOSE :OFF DOOR SW-AS OPEN :ON CLOSE :OFF Without CONSULT-III
Check voltage between BCM connector and ground.
BCM CONNECTOR AND GROUNDItem Connector Terminals Door condition Voltage (V)
(Approx.)(+) (-) RH M18 12 Ground OPEN 0 CLOSE Battery voltage LH M19 47 OPEN 0 CLOSE Battery voltage OK or NG
OK: Door switches are OK.
NG: GO TO 2.
- CHECK DOOR SWITCH CIRCUIT
- Turn ignition switch OFF.
- Disconnect front door switches and BCM.
- Check continuity between front door switch connector B8 (LH) or B108 (RH) terminal 2 and BCM connector M18, M19 terminals 12,47.
Front door switch LH
2 - 47: Continuity should exist.
Front door switch RH
2 - 12: Continuity should exist.
- Check continuity between front door switch connector B8 (LH) or B108 (RH) terminal 2 and ground.
2 - Ground: Continuity should not exist.
Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
OK: GO TO 3.
NG: Repair or replace harness.
- CHECK DOOR SWITCH
Check continuity between each door switch terminal 2 and body ground part of door switch.
DOOR SWITCHTerminal Door switch Continuity 2 Body ground part of door switch Pushed No Released Yes Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
OK: Further inspection is necessary. Refer to "TROUBLE DIAGNOSIS CHART BY SYMPTOM ".
NG: Replace malfunctioning door switch.