LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 2082 (Brake System) >> Rear Disc Brake >> Disassembly and Assembly of Caliper Assembly >> Disassembly

Disassembly and Assembly of Caliper Assembly: Disassembly

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove caliper assembly. Refer to "REMOVAL .
  2. Remove sliding pin boot from torque member.
  3. Remove the retaining ring from the cylinder body using a screwdriver or suitable tool, as shown.
    Fig 1: Identifying Retaining Ring
    G04876708Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Place a wooden block as shown, and blow air from union bolt mounting hole to remove pistons and piston boots.
    WARNING: Do not place your finger in front of piston.
    Fig 2: Blowing Air From Union Bolt
    G04876709Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Remove piston seals from cylinder body using a screwdriver or suitable tool, as shown.
    CAUTION: Be careful not to damage cylinder inner wall.
    Fig 3: Identifying Piston Seal
    G04902227Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals