Removal and Installation: Installation
WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- Loosen the lock nut to adjust the input rod length so that the dimension shown satisfies the specified value.
Approximate value: 125 mm (4.92 in)
- After adjusting, temporarily tighten the lock nut to install the booster assembly to the vehicle. At this time, make sure to install a gasket between the booster assembly and the vehicle.
- Connect the brake pedal with the clevis of the input rod.
- Install the brake pedal assembly nuts.
- Install the brake piping from the brake master cylinder to ABS actuator. Refer to "HYDRAULIC CIRCUIT .
- Install the brake master cylinder to the brake booster. Refer to "REMOVAL AND INSTALLATION .
- Adjust brake pedal. Refer to "INSPECTION AND ADJUSTMENT .
- Tighten the lock nut of the input rod.
- Refill reservoir with new brake fluid and bleed air. Refer to "BLEEDING BRAKE SYSTEM .