LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 2011 (Front Axle) >> Wheel Hub >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove wheel and tire using power tool.
  2. Without disassembling the hydraulic lines, remove caliper torque member bolts using power tool. Then reposition brake caliper aside with wire. Refer to "REMOVAL AND INSTALLATION OF BRAKE CALIPER AND DISC ROTOR ".
    CAUTION: Do not press brake pedal while brake caliper is removed.
  3. Put alignment mark on disc rotor and wheel hub and bearing assembly, then remove disc rotor.
    Fig 1: Identifying Alignment Marks
    G04901994
  4. Remove cotter pin, then remove lock nut from drive shaft using power tool. Refer to "REMOVAL AND INSTALLATION ".
  5. Remove drive shaft from wheel hub and bearing assembly. Refer to "REMOVAL AND INSTALLATION ".
  6. Remove wheel sensor from wheel hub and bearing assembly. Refer to "REMOVAL AND INSTALLATION ".
    • Inspect the wheel sensor O-ring, replace the wheel sensor assembly if damaged.
    • Clean the wheel sensor hole and mounting surface with a suitable brake cleaner and clean lint-free shop rag. Be careful that dirt and debris do not enter the axle bearing area.
    • Apply a coat of suitable grease to the wheel sensor O-ring and mounting hole.
    CAUTION: Do not pull on the wheel sensor harness.
  7. Remove wheel hub and bearing assembly bolts using power tool.
  8. Remove splash guard and wheel hub and bearing assembly from steering knuckle.
    • Carefully remove wheel sensor and harness through hole in splash guard.
scientia non olet · About LEMON Manuals