Rear Case

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Apply petroleum jelly to the circumference of the new rear oil seal. Install the new rear oil seal so that it is flush with the case tip face using Tool.
Tool number : ST30720000 (J-25405)
CAUTION:
- Do not reuse oil seal.
- Apply petroleum jelly to seal lip before installing.
  
  Fig 1: Identifying Rear Oil Seal
Apply petroleum jelly to the circumference of the new dust cover. Position the new dust cover using the identification mark as shown.
CAUTION:
- Do not reuse dust cover.
- Position the identification mark at the position shown.
  
  Fig 2: Identifying Identification Mark Position
Install the new dust cover using Tool.
Tool number : KV40105310 ( - )

Fig 3: Tapping Dust Cover
Install the air breather into the rear case.
Remove all the sealant from the rear case to center case mating surfaces.
CAUTION: Remove all foreign materials such as water, oil, and grease from center case and rear case mating surfaces.
Apply liquid gasket to the entire rear case mating surface of the center case.
- Use Genuine Anaerobic Liquid Gasket or equivalent. Refer to "RECOMMENDED CHEMICAL PRODUCTS AND SEALANTS ".
CAUTION: Do not to allow Liquid Gasket to enter stem bleeder hole.
Install the rear case to the center case. Tighten the bolts to the specified torque. Refer to "COMPONENTS ".

Fig 4: Identifying Rear Case Bolts