Door Mirror Remote Control Switch Ground Circuit Inspection

WARNING: This page is about a different car, the 2006 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

CHECK DOOR MIRROR REMOTE CONTROL SWITCH GROUND CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect door mirror remote control switch.
3. Check continuity between door mirror remote control switch connector D10 terminal 7 and ground.
  13 - Ground : Continuity should exist.
  
  Fig 1: Identifying Door Mirror Remote Control Switch Ground Circuit
OK or NG

OK : GO TO 2.

NG : Repair or replace harness.

CHECK DOOR MIRROR REMOTE CONTROL SWITCH (CHANGEOVER SWITCH)

Check continuity between door mirror remote control switch terminals as follows.

CONTINUITY SPECIFICATIONS

Terminals		Condition	Continuity
3	13	Changeover switch RIGHT position	Yes
3		Other than above	No
2		Changeover switch LEFT position	Yes
2		Other than above	No

Fig 2: Identifying Door Mirror Remote Control Switch (Changeover Switch)

OK or NG

OK : Check the condition of the harness and the connector.

NG : Replace door mirror remote control switch.