Steering Pad: Installation

WARNING: This page is about a different car, the 2006 Scion tC. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see PRECAUTION ).

INSTALL STEERING PAD ASSEMBLY
1. Support the steering pad with one hand as shown in the illustration.
2. Connect the 2 airbag connectors.
  NOTE: When handling the airbag connector, do not damage the airbag wire harness.
3. Connect the horn connector.
4. Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.
5. Using a T30 "torx" socket, install the 2 screws.
Torque: 8.8 N*m (90 kgf*cm, 78 in.*lbf)

Fig 1: Connecting Airbag Connectors
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSPECT STEERING PAD ASSEMBLY
1. Check for cuts, cracks or discoloration on the steering pad outer surface and in the grooved portion.
2. Check that the horn sounds.
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
CAUTION: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
CHECK SRS WARNING LIGHT
1. Check the SRS warning light (see DIAGNOSIS SYSTEM ).