LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 1934 (Supplemental Restraint System) >> Rear Airbag Sensor >> Installation

Rear Airbag Sensor: Installation

WARNING: This page is about a different car, the 2006 Scion tC. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see PRECAUTION  )).
  1. INSTALL AIRBAG SENSOR REAR LH 
    1. Install the airbag sensor with the 2 nuts.

      Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf) 

      NOTE:
      • If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
      • When installing the airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
  2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (See  INSTALLATION  ) 
  3. INSTALL FRONT DOOR WEATHERSTRIP LH 
  4. INSTALL FRONT DOOR SCUFF PLATE LH (See  INSTALLATION  ) 
  5. INSTALL TONNEAU COVER ASSEMBLY 
  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  7. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
    NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
  8. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (see DIAGNOSIS SYSTEM  ).
scientia non olet · About LEMON Manuals