LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 1814 (Seats) >> Front Seat >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2006 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • When checking the power seat circuit for continuity using a circuit tester, do not confuse its connector with the side air bag module connector. Such an error may cause the air bag to deploy.
  • Before removing the front seat, turn the ignition switch off, disconnect both battery cables and wait at lease 3 minutes.
CAUTION:
  • Do not drop, tilt, or bump the side air bag module while installing the seat. Always handle it with care.
  • Front passenger seat is equipped with an Occupant Classification System sensor and control module. Do not disassemble front passenger seat cushion assembly or remove the trim as this will affect the Occupant Classification System calibration.
  • If the vehicle has been involved in a collision, the seat must be inspected for damage. Refer to "COLLISION DIAGNOSIS "
  • After front side air bag module inflates, front seatback assembly must be replaced.
NOTE:
  • When removing and installing the seat, use shop cloths to protect the vehicle from damage.
  • When removing or installing the seat trim, handle it carefully to keep dirt out and avoid damage.
  1. Slide the seat until the four body mounting bolts are visible and a tool can be inserted.
  2. Disconnect both battery cables and wait at least 3 minutes.
  3. Disconnect the side air bag module harness connector.
  4. Remove the four body mounting bolts.
  5. Disconnect the power seat harness connectors (if equipped) and remove the seat from the vehicle.
scientia non olet · About LEMON Manuals