Special Service Tools
WARNING: This page is about a different car, the 2006 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.
SPECIAL SERVICE TOOLS DESCRIPTION
| Tool number (Kent-Moore No.) Tool name |
Description | |
|---|---|---|
| ST0501S000 ( - ) Engine stand assembly 1 ST05011000 ( - ) Engine stand 2 ST05012000 ( - ) Base |
Disassembling and assembling | |
| - (J-47242) Engine support table |
Engine and transmission assembly removal | |
| KV10106500 ( - ) Engine stand shaft |
Disassembling and assembling | |
| KV10117000 (J-41262) Engine sub-attachment |
KV10117000 has been replaced with KV10117001 (KV10117000 is no longer in production, but is usable). | |
| KV10117001 ( - ) Engine sub-attachment |
Installing on the cylinder block | |
| KV10116200 (J-26336-B) Valve spring compressor 1 KV10115900 (J-26336-20) Attachment 2 KV1019230 ( - ) |
Disassembling valve mechanism Part (1) is a component of KV10116200 (J-26336-B), but Part (2) is not. |
|
| KV10107902 (J-38959) Valve oil seal puller |
Removing valve oil seal | |
| (J-39386) Valve oil seal drift |
Installing valve oil seal | |
| KV991J0120 (J-47128) Seal installer |
Installing rear main seal | |
| EM03470000 (J-8037) Piston ring compressor |
Installing piston assembly into cylinder bore | |
| ST16610001 (J-23907) Pilot bushing puller |
Removing crankshaft pilot bushing | |
| KV10111100 (J-37228) Seal cutter |
Removing steel oil pan and rear timing chain case | |
| WS39930000 ( - ) Tube presser |
Pressing the tube of liquid gasket | |
| KV10112100 (BT-8653-A) Angle wrench |
Tightening bolts for bearing cap, cylinder head, etc. | |
| KV991J0050 (J-44626) Air fuel sensor Socket |
Loosening or tightening air fuel ratio A/F sensor a: 22 mm (0.87 in) Unit: mm (in) |
|
| KV10114400 (J-38365) Heated oxygen sensor wrench |
Loosening or tightening rear heated oxygen sensor a: 22 (0.87) Unit: mm (in) |
|
| KV10117700 (J-44716) Ring gear stopper |
Removing and installing crankshaft pulley | |
| - (J-45488) Quick connector release |
Disconnecting fuel tube quick disconnect connectors in engine compartment | |
| KV10109300 ( - ) Puller holder |
Removing and installing crankshaft pulley a: 68 (2.68) dia. b: 8 (0.31) Unit: mm (in) |