All Signals, Main Signals, Select From Menu
WARNING: This page is about a different car, the 2006 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
CONSULT-II SCREEN VALUE DESCRIPTION CHART
| Item name | CONSULT-II screen display | Display or unit | Monitor item selection | Description | ||||
|---|---|---|---|---|---|---|---|---|
| ALL SIGNALS | MAIN SIGNALS | SELECTION FROM MENU | ||||||
| Motor fan request | MOTOR FAN REQ | 1/2/3/4 | X | X | X | Signal status input from ECM | ||
| Compressor request | AC COMP REQ | ON/OFF | X | X | X | Signal status input from ECM | ||
| Parking, license, and tail lamp request | TAIL & CLR REQ | ON/OFF | X | X | X | Signal status input from BCM | ||
| Headlamp low beam request | HL LO REQ | ON/OFF | X | X | X | Signal status input from BCM | ||
| Headlamp high beam request | HL HI REQ | ON/OFF | X | X | X | Signal status input from BCM | ||
| Front fog request | FR FOG REQ | ON/OFF | X | X | X | Signal status input from BCM | ||
| FR wiper request | FR WIP REQ | STOP/1LO/LO/HI | X | X | X | Signal status input from BCM | ||
| Wiper auto stop | WIP AUTO STOP | ACT P/STOP P | X | X | X | Output status of IPDM E/R | ||
| Wiper protection | WIP PROT | OFF/LS/HS/Block | X | X | X | Control status of IPDM E/R | ||
| Starter request | ST RLY REQ | ON/OFF | X | X | Status of input signal NOTE | |||
| Ignition relay status | IGN RLY ON/OFF | X | X | X | X | Ignition relay status monitored with IPDM E/R | ||
| Rear defogger request | RR DEF REQ | ON/OFF | X | X | X | Signal status input from BCM | ||
| Oil pressure switch | OIL P SW | OPEN/CLOSE | X | X | Signal status input from IPDM E/R | |||
| Hood switch | HOOD SW ((1)) | OFF | X | Signal status input from IPDM E/R | ||||
| Theft warning horn request | THFT HRN REQ ((1)) | ON/OFF | X | X | Signal status input from BCM | |||
| Horn chirp | HORN CHIRP | ON/OFF | X | X | Output status of IPDM E/R | |||
| Cornering lamp request | CRNRNG LMP REQ | OFF/LEFT/RIGHT | X | X | Signal status input from BCM | |||
|
NOTE:
Perform monitoring of IPDM E/R data with the ignition switch ON. When the ignition switch is in ACC position, display may not be correct.
|
||||||||
|
||||||||